|
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||
Combining the positive experiences gained during the years of designing Light Emitting Diode (LED) based signal lights for application in marine visual aids to navigation systems, and the successful E58 product range of high quality robust LED Indicator Panels for industrial applications, Cybernetica team has designed a new LED Spotlight E5711 product family for use as a high reliability low power light source for environmentally demanding applications. E5711 is intended for use as a working light in industrial, architectural, or other similar applications, but it is also expected to find use as a signal light due to clearly defined parameters of it's light beam.
The light unit of the LED Spotlight E5711 is built upon a 10 mm aluminium alloy (EN AW-6063) base plate with a protective visor, integrating 5 high-power market leading Luxeon III Star LEDs with off-the-shelf lenses of choice under a clear UV-stable Makrolon® (by Bayer AG) polycarbonate cupola. Product versions with wide elliptic light beam, medium, or narrow circular light beam are available. The electronics part, a temperature controlled linear power supply, is potted in resin, providing constant current to the LEDs and guaranteeing low RF emissions as well as long product lifetime under specified range of environmental operating temperatures. The LED current and thus the light output is gradually limited at the temperatures above 30°C. Power is supplied using the same 5-pole M12 receptacle used on E581X LED Indicator Panels. The assembly is fully sealed and has no user-serviceable parts inside, providing practically maintenance free lifetime, once installed and used according to the supplied instructions.
The E5711 LED Spotlight is supplied with a dedicated U-clamp manufactured of 6mm sheet aluminium as shown above. Alternatively, the light unit can be surface mounted using four 10mm holes at each corner, located within a rectangle of 120 mm (W) x 110 mm (H); in this case, the M12 power supply connector in the upper middle section of the back side requires attention. A set of high quality A4 stainless steel hex head M6 bolts is supplied for mounting and positioning the LED unit inside the clamp. The Spotlight is supplied in black polyurethane powder coated finish. Mounting of the U-clamp on a pipe or rail of up to 55mm diameter is an option.
While the white E5711.W.L unit with elliptic light beam is starting the product family, versions with circular light beam emitting Red, Green, Yellow, and Blue light for illumination of objects and surfaces will be available for ordering.
More detailed information, including the information on prices and availability of our products, can be obtained from our marketing group. CAUTION: LED light units are sources of bright light, do not stare directly into the beam from close distances and observe all the warnings and guidelines in the Instruction Manual. ekta™ E5711 LED Spotlights are classified as Class 3R LED devices according to the standard IEC 60825-1:1993+A1:1997+A2:2001. Note: The manufacturer reserves the right to change this specification without prior notice. Makrolon® is a registered trademark of Bayer AG, Leverkusen, Germany.
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||
